|
|
The end pieces are fastened to the side pieces with 2 - 3 ½"
deck screws at each corner. Pre-drill 1/8" holes into end
pieces and check the frame for squareness before assembly. |
|
|
Roll the mesh onto the frame and fasten with staples at four-inch
intervals. Trim excess mesh if necessary. |
|
Use a 1" spade bit on each leg to recess the hex bold heads.
Drill a 3/8" hole through each leg and the frame after drilling
the countersink. |
|
|
|
Attach the legs to the frame with 3 ½" hex bolts,
placing a washer in the space between the boards and at each
end of the bolts. Secure the nut to allow movement of the legs. |
|
|
